Ford Mustang (1999-2004) Service Manual: Driveline Angle
| Item | Description |
| 1 | Bottom of the frame |
| 2 | Engine crankshaft centerline |
| 3 | Engine angle |
| 4 | Driveshaft and coupling shaft centerline |
| 5 | Driveshaft and coupling shaft angle |
| 6 | Rear axle pinion centerline |
| 7 | Axle pinion angle |
An incorrect driveline (pinion) angle can often be detected by the driving condition in which the vibration occurs.
- A vibration during coastdown from 72 to 56 km/h (45 to 35 mph) is often caused by an excessive U-joint angle at the axle (pinion nose downward).
- A vibration during acceleration, from 56 to 72 km/h (35 to 45 mph) may indicate an excessive Ujoint angle at the axle (pinion nose upward).
When these conditions exist, check the driveline angles as described in the General Procedures portion of this section.
If the tires and driveline angle are not the cause, carry out the NVH tests to determine whether the concern is caused by a condition in the axle.
Universal Joint (U-Joint) Wear
Place the vehicle on a frame hoist and rotate the driveshaft by hand. Check for rough operation or seized U-joints. Install a new U-joint if it shows signs of seizure, excessive wear, or incorrect seating.
Analysis of Vibration
WARNING: A vehicle equipped with a Traction-Lok differential will
always have both
wheels driving. If only one wheel is raised off the floor and the rear axle is
driven by the engine,
the wheel on t ...
Wheel Hub or Axle Flange Bolt Circle Runout
NOTE: The brake discs must be removed to carry out all runout
measurements.
1. Position the special tool perpendicular to the wheel hub or axle flange bolt,
as close to the hub
or flange face as po ...
Other materials:
Axle Housing
Special Tool(s)
Plug Set, Differential
205-294 (T89P-4850-B)
Protector, Differential Seal
(Pair)
205-461
Remover, Halfshaft
205-475
Remover, Steering Arm
211-003 (T64P-3590-F)
...
Assembly
1. NOTE: One tab that locks the reverse clutch drum into the reverse
sun shell may be removed.
This is done for balancing purposes.
Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate
serrations for scores or
burrs. Minor scores or bu ...
Torque Converter Leak Check
Special Tool(s)
Leak Tester, Torque Converter
307-421
1. Clean the outside surface of the torque converter.
2. Install the special tool into the converter hub.
3. WARNING: Always follow correct safety procedures while using press.
Failure t ...
