Ford Mustang (1999-2004) Service Manual: Engine Coolant Temperature (ECT) Sensor - Cobra
Material
Item | Specification |
Pipe Sealant with Teflon D8AZ-19554-A | WSK-M2G350-A2 |
Removal and Installation
1. Partially drain the engine cooling system. For additional information, refer to Section.
2. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
3. Remove the ECT sensor
4. To install, reverse the removal procedure.
- Apply sealant to the ECT sensor threads.
Engine Coolant Temperature (ECT) Sensor - 4.6L (2V)
Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Partially drain the cooling system. For additional information, refer to Section. 3. Disc ...Engine Coolant Temperature (ECT) Sensor - Mach I
Material Item Specification Pipe Sealant with Teflon D8AZ-19554-A WSK-M2G350-A2 Removal and Installation 1. Remove the air intake scoop. For additional information, refer to S ...Other materials:
Hydro-Boost Bleeding
1. NOTE: The Hydro-Boost power brake booster (2B560) is generally
self-bleeding, and the
following procedure will normally bleed the air from the power brake booster.
Normal operation
of the vehicle will further remove any additional trapped air.
Fill the p ...
Removal
1. Remove the center instrument panel register.
2. Remove the screws.
3. Disconnect the connectors.
4. Using the special tool, disconnect the temperature control cable from the
control head.
5. Remove the nuts and disconnect the vacuum connector.
...
Module - Daytime Running Lamps (DRL)
Removal
1. CAUTION: Electronic modules are sensitive to static electrical
charges. If exposed
to these charges, damage can result.
Disconnect the battery ground cable.
2. Remove the daytime running lamps (DRL) module and bracket assembly
(15A270).
...