Ford Mustang (1999-2004) Service Manual: Exhaust Gas Recirculation (EGR) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional information, refer to Section.
2. Remove the exhaust gas recirculation (EGR) valve.
1. Disconnect the EGR tube upper fitting.
2. Disconnect the vacuum hose.
3. Remove the two bolts and remove the EGR valve and gasket.
3. CAUTION: Do not use metal scrapers, wire brushes, power abrasive disks or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Clean and inspect the mating surfaces.
4. To install, reverse the removal procedure.
- Install a new gasket.
Exhaust Gas Recirculation (EGR) Valve - Cobra
Removal and Installation 1. Disconnect the accelerator cable and the speed control cable. 2. Remove the accelerator cable bracket bolts. 3. Release the clip and position the accelerator cable bra ...Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube
Removal and Installation NOTE: 3.8L shown, 4.6L (2V) similar. 1. With the vehicle in NEUTRAL, position it on a hoist. 2. Disconnect the exhaust gas recirculation (EGR) valve tube from the exhaus ...Other materials:
Engine Mount RH
Special Tool(s)
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Support Bar, Engine
303-290-A
Removal
1. Install the special tool.
2. Install the special tools.
3. Remove the starter. For additional information, refer to Secti ...
Supercharger Cooling (Diagnosis and Testing)
Special Tool(s)
Pressure Test Kit
014-R1072 or equivalent
Battery/Antifreeze Tester
014-R1060 or equivalent
Material
Item
Specification
Motorcraft Premium
Engine Coolant
VC-4-A (in Oregon
VC-5, in Canada
C ...
Pinpoint Test L: B1892 - Air Bag Tone Warning Indicator Circuit Shorted to
Ground or Open
Normal Operation
The restraints control module (RCM) monitors its connection to the
generic electronic module (GEM) at
C201e pin 10. This connection is used to signal a chime if the air bag
indicator is inoperative and
another SRS fault exists. If the R ...