Ford Mustang (1999-2004) Service Manual: Exhaust Manifold RH
Removal and Installation
1. Disconnect the battery negative cable. For additional information, refer to Section.
2. Remove the air cleaner outlet pipe. For additional information, refer to Section.
3. Disconnect the differential pressure feedback exhaust gas recirculation (EGR) system electrical and vacuum connections.
4. Disconnect the EGR tube.
5. Remove the EGR tube.
6. Raise and support the vehicle. For additional information, refer to Section.
7. Remove the LH exhaust manifold flange nuts.
8. Remove the RH exhaust manifold flange nuts.
9. Lower the vehicle.
10. NOTE: Discard the exhaust manifold gasket.
Remove the RH exhaust manifold retaining nuts and the RH exhaust manifold.
11. To install, reverse the removal procedure. Tighten the exhaust manifold nuts in the sequence shown.
Exhaust Manifold - LH
Removal 1. Raise and support the vehicle. For additional information, refer to Section. 2. Remove the LH exhaust manifold flange nuts. 3. Remove the RH exhaust manifold flange nuts. 4. Lower ...Cylinder Head LH
Special Tool(s) Remover, Power Steering Pump Pulley 211-016 (T69L-10300-B) Installer, Power Steering Pump Pulley 211-009 Material ...Other materials:
Exhaust Manifold - LH
Removal
1. Raise and support the vehicle. For additional information, refer to
Section.
2. Remove the LH exhaust manifold flange nuts.
3. Remove the RH exhaust manifold flange nuts.
4. Lower the vehicle.
5. NOTE: Discard the exhaust manifold gasket.
...
Four Wheel Anti-Lock Brake System (4WABS) Hydraulic Control Unit (HCU)
NOTE: This procedure only needs to be performed if the 4-wheel
anti-lock brake (4WABS) hydraulic
control unit (HCU) has been installed new or if the HCU lines have been
opened.
1. Clean all dirt from and remove the brake master cylinder filler cap
...
Installation
NOTE: Do not use a fiber disc to clean the surfaces. Fibers from
the disc can get into the oil pan and
oil and clog the oil bypass valve.
1. Clean and inspect the cylinder head for flatness.
2. Install a new head gasket on the cylinder block with the sma ...