Ford Mustang (1999-2004) Service Manual: Fuel Tank Draining

Special Tool(s)

Fuel Storage Tanker 164-R3202 or equivalent
Fuel Tank Drain Hose 310-F013

WARNING: Do not smoke or carry lighted tobacco or an open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the fuel tank filler cap.

3. Insert the hose guide into the filler neck.

Fuel Tank Draining

4. NOTE: Insert the hose until the stop contacts the guide tube. If the stop does not contact the guide tube, remove the hose and repeat the procedure.

Insert the chamfered end of the hose into the filler neck through the guide tube.

Fuel Tank Draining

5. Attach the Fuel Storage Tanker to the hose and remove the fuel.

6. Remove the hose and the hose guide.

    Pressure Relief
    Special Tool(s) Fuel Pressure Gauge 310-012 (T80L-9974-B) WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. ...

    Spring Lock Couplings
    Special Tool(s) Disconnect Tool, Spring Lock Coupling (3/8 inch yellow) 310-D004 (D87L-9280-A) or equivalent Disconnect Tool, Spring Lock Coupling (1/2 inch green) 310 ...

    Other materials:

    Throttle Body
    Removal and Installation WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may ignite. Failure to follow these instructions may resul ...

    Seats (Description and Operation)
      Seats - Front Power The front power seat features: a six-way seat regulator control switch (14A701) located on the front of the seat. a seat track (61705) mounted under the seat. a seat regulator motor (14547) and gear housing mounted on ...

    Trim Panel - Upper Quarter
    Special Tool(s) Safety Belt Bolt Bit 501-010 (T77L-2100-A) Removal and Installation 1. Remove the rear seat cushion. 2. Using the special tool, remove the rear safety belt anchor bolt. 3. Remove the screw and the coat hook. 4. Open the ...