Ford Mustang (1999-2004) Service Manual: Fuel Vapor Control Tube Assembly Valve
Removal and Installation
1. Remove the fuel tank. For additional information, refer to Section.
2. Remove the retainers.
3. NOTE: The fuel vapor vent valve, fuel vapor control valve and the in-line fuel tank pressure sensor are repaired as a fuel vapor control valve tube assembly.
NOTE: It may be necessary to lubricate the fuel vapor control valve tube assembly grommets with ESE-M00B144-B Merpol or equivalent to assist in the removal procedure.
Remove the fuel vapor control valve tube assembly.
1. Loosen the fuel vapor vent valve.
2. Loosen the fuel vapor control valve.
3. Remove the fuel vapor control valve tube assembly.
4. NOTE: Lubricate all O-ring seals with MERPOL O-Ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.
NOTE: New grommets are necessary when the fuel vapor control valve tube assembly is removed.
To install, reverse the removal procedure.
- Leak test the system. For additional information, refer to Evaporative Emission System Leak Test in this section.
- Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair Verification Drive Cycle in this section.
Fuel Tank Pressure Sensor
Removal and Installation
1. NOTE: The in-line fuel tank pressure sensor is repaired along with the fuel vapor vent valve and the fuel vapor control valve as a fuel vapor control valve tube assembly.
For removal and installation of the fuel vapor control valve, refer to Fuel Vapor Control Tube Assembly Valve in this section.
Evaporative Emission Canister Purge Valve
Removal and Installation 1. WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not in large quantities, it still presents the danger of explosion ...Evaporative Emission Test Port
Removal and Installation 1. Disconnect the pin-type retainer. 2. Raise and support the vehicle. For additional information, refer to Section. 3. Remove the RH front wheel. For additional informa ...Other materials:
Electronic Engine Controls - Cobra
Most of the Cobra engine electronic controls are similar to that of
the non-supercharged 4.6L (2V)
engine. These components are as follows:
Crankshaft position (CKP) sensor
Throttle position (TP) sensor
Idle air control (IAC) valve
Mass air ...
Pinion Seal
Special Tool(s)
Installer, Drive Pinion Oil Seal
205-133 (T79P-4676-A)
Removal
1. Remove the pinion flange (4851). For additional information, refer to
Drive Pinion Flange in this
section.
2. Force up the metal flange of the rear axle drive p ...
Removal
1. Remove the roller followers. For additional information, refer to Roller
Followers in this section.
2. Remove the spark plugs. For additional information, refer to Section .
3. Position the piston of the cylinder being serviced at the bottom of the
stro ...