Ford Mustang (1999-2004) Service Manual: Evaporative Emissions
General Specifications
Torque Specifications
- Evaporative Emissions (Description and Operation)
- Evaporative Emissions (Diagnosis and Testing)
- Canister Vent Solenoid Closing Procedure
- Evaporative Emission System Leak Test
- Evaporative Emission Repair Verification Drive Cycle
- Evaporative Emission Canister
- Evaporative Emission Canister Purge Valve
- Fuel Vapor Control Tube Assembly Valve
- Evaporative Emission Test Port
Charge Air Cooler
Material
Item
Specification
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
WSE-M4G323-EA
Removal and Installation
1. Drain the supercharger coolant. For additional inform ...
Evaporative Emissions (Description and Operation)
Component Location
The evaporative emission system:
is equipped with an on-board refueling vapor recovery (ORVR) system.
prevents hydrocarbon emissions from reaching the atmosphere.
...
Other materials:
Air Distribution
NOTE: The air distribution system of this vehicle cannot be equipped
with a cabin air filter.
There are two sources of air available to the air distribution system:
outside air
recirculated air
Recirculated air is only used during MAX A/C.
Air distribut ...
Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information
refer to Section.
2. Disconnect the cylinder head temperature sensor connector.
3. Remove the CHT sensor.
Installation
1. To install, reverse the removal procedure. ...
Accelerator Cable - 4.6L (2V)
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating ...
