Ford Mustang (1999-2004) Service Manual: Ignition Coil-On-Plug

Material

Item Specification
Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent ESE-M1C171- A

Removal and Installation

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the air cleaner outlet pipe. For additional information, refer to Section.

3. Remove the RH ignition coil cover bolts and the cover.

Ignition Coil-On-Plug

4. Remove the ignition coils.

1. Disconnect the electrical connectors.

2. Remove the ignition coils.

Ignition Coil-On-Plug

5. Remove the LH ignition coil cover bolts and the cover.

Ignition Coil-On-Plug

6. Remove the ignition coils.

1. Disconnect the connectors.

2. Remove the ignition coils.

Ignition Coil-On-Plug

7. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.

To install, reverse the removal procedure.

  • Apply a light coat of dielectric grease to the inside of the ignition coil boots.
    Engine Ignition (Description and Operation)
    Eight separate ignition coils: are controlled by the powertrain control module (PCM). are mounted directly above each spark plug. are controlled by the powertrain control module for correct fi ...

    Spark Plugs
    Removal and Installation 1. Remove the ignition coil-on-plug. For additional information, refer to Ignition Coil-On-Plug in this section. 2. NOTE: Use compressed air to remove any foreign materi ...

    Other materials:

    Valve Cover LH
    Material Item Specification Silicone Gasket and Sealant F7AZ-19554-EA or equivalent WSE-M4G323-A4 Removal and Installation 1. Position the oil level tube (6754) out of the way. 2. Disconnect the breather tube. 3. Separate the engine wir ...

    Intake Air Distribution and Filtering
    Torque Specifications a - Refer to the procedure Intake Air Distribution and Filtering (DESCRIPTION AND OPERATION) The air intake system consists of the: air intake scoop (Mach I) air cleaner (ACL). air cleaner (ACL) element. mass air flow (MAF) s ...

    Engine - 3.8L
    General Specifications a - 20-200 seconds to leakdown 3.18 mm (0.125 in) with 225 Newtons (50 pounds) load and tappet filled with leak-down fluid. Torque Specifications a - Refer to the procedure in this section b - Advance one-half turn aft ...