Ford Mustang (1999-2004) Service Manual: Ignition Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch drift, press the ignition switch lock cylinder release pin through the access hole while pulling out the ignition switch lock cylinder.
3. To install, reverse the removal procedure.
- Verify ignition switch lock cylinder operation.
Handle - Interior Door
Removal 1. Remove the door trim panel (23942). For additional information, refer to Section. 2. Remove the rivet. 3. Remove the cable clip. 4. Release the cable housing from the interior h ...Ignition Lock Cylinder - Non-Functional
Removal and Installation 1. NOTE: Make sure the front wheels are in the straight-ahead position. Disconnect the battery ground cable (14301) and wait at least one minute to allow the deplet ...Other materials:
Assembly
1. NOTE: Universal joint service kits are to be installed as complete
assemblies only. Do not mix
components from other U-joint kits.
Install the bearing cup.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct po ...
Striker Adjustment
NOTE: After adjusting the door latch striker plate, verify that the
door can be closed easily and fits
tightly.
1. Loosen the door latch striker plate bolts.
2. Reposition the door latch striker plate from side to side or up and down
as necessary.
...
Wheel Hub or Axle Flange Bolt Circle Runout
NOTE: The brake discs must be removed to carry out all runout
measurements.
1. Position the special tool perpendicular to the wheel hub or axle flange bolt,
as close to the hub
or flange face as possible. Zero the indicator to allow the pointer to deflect
...