Ford Mustang (1999-2004) Service Manual: Handles, Locks, Latches and Mechanisms
General Specifications
Torque Specifications
LOCK REPAIR/REPLACEMENT SPECIFICATIONS
- Handles, Locks, Latches And Mechanisms (Description and Operation)
- Latch - Door
- Latch - Luggage Compartment Lid
- Handle - Exterior Door
- Handle - Interior Door
- Ignition Lock Cylinder - Functional
- Ignition Lock Cylinder - Non-Functional
- Lock Cylinder - Door
- Lock Cylinder - Luggage Compartment Lid
- Actuator - Door Lock
- Switch - Door Lock
- Keyless Entry (Diagnosis and Testing)
Floor Console
Removal and Installation
All vehicles
1. Disconnect the battery ground cable. For additional information,
refer to Section .
2. Apply the parking brake.
Vehicles with automatic transmissio ...
Handles, Locks, Latches And Mechanisms (Description and Operation)
Lock Cylinders
Individual lock cylinders are repaired by discarding the inoperative
lock cylinder and building a new
lock cylinder using the appropriate lock repair package. The lock repair
...
Other materials:
Idle Air Control (IAC) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional
information, refer to Section.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the bolts, the IAC valve and the gasket.
4. NOTE: Install a new ga ...
Reservoir - CIII Pump
Removal
1. Remove the bolts.
2. Disconnect the power steering hoses. Remove the reservoir.
Installation
1. To install, reverse the removal procedure.
2. Fill and leak check the power steering system. ...
Input Shaft and Bearing
Special Tool(s)
Remover, Driver Pinion
Bearing Cone
205-D002 (D79L-4621-A) or
equivalent
Installer, Drive Pinion Bearing
Cone
205-011 (T57L-4621-B)
Remover/Installer, Bearing
Tube
308-024 (T75L-7025-B)
Disas ...
