Ford Mustang (1999-2004) Service Manual: Lock Cylinder - Door
Removal
1. NOTE: Individual lock cylinders are repaired by discarding the inoperative cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
Remove the door trim panel (23942). For additional information, refer to Section.
2. Using a screwdriver, release the lock cylinder actuating rod.
3. Remove the door lock cylinder retainer.
4. Remove the door lock cylinder (21990).
5. If necessary, transfer the lock cylinder arm to the new door lock cylinder (21990).
Installation
1. To install, reverse the removal procedure.
Ignition Lock Cylinder - Non-Functional
Removal and Installation 1. NOTE: Make sure the front wheels are in the straight-ahead position. Disconnect the battery ground cable (14301) and wait at least one minute to allow the deplet ...Lock Cylinder - Luggage Compartment Lid
Removal 1. NOTE: Individual lock cylinders are repaired by discarding the inoperative cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair pac ...Other materials:
Axle Assembly
Removal and Installation
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark before
tightening the
suspens ...
Installation
1. Install the bearing, snap ring, hub and dust shield. For additional
information, refer to Wheel
Hub-Cobra in this section.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do ...
Cooler - Fluid
Removal
1. Raise and support the vehicle.
2. Disconnect the power steering hoses.
3. Remove the bolt and routing bracket.
4. Remove the bolts and the power steering fluid cooler.
Installation
1. To install, reverse the removal procedure.
2. Fill and ...