Ford Mustang (1999-2004) Service Manual: Lumbar Motor

Removal and Installation

All vehicles

1. Remove the front seat. For additional information, refer to Seat-Front Power in this section.

2. Disconnect the power seat track electrical connector.

Lumbar Motor

3. Remove the four seat track bolts.

Lumbar Motor

Vehicles with standard power lumbar

4. Release the J-clip.

Lumbar Motor

5. Remove the front seat backrest pad adjusting pump screws.

Lumbar Motor

6. Remove the front seat backrest pad adjusting pump (65530).

1. Disconnect the electrical connector.

2. Disconnect the power lumbar support air hose.

Lumbar Motor

Vehicles with power bolster and lumbar

7. Remove the driver seat backrest latch. For additional information, refer to Latch-Front Seat Backrest in this section.

8. Remove the pivot bolt and seat backrest.

  • Disconnect the power lumbar support air hoses.

Lumbar Motor

9. Release the J-clips.

Lumbar Motor

10. NOTE: When removing the cushion from the frame, it is not necessary to remove the trim cover from the cushion foam pad.

Remove the cushion foam pad from the frame.

11. NOTE: The lumbar and bolster pump and solenoid module is serviced as part of the cushion frame assembly.

Install a new seat cushion frame assembly.

All vehicles

12. To install, reverse the removal procedure.

    Seat Track
    Removal and Installation 1. Remove the front seat. For additional information, refer to Seat-Front Power in this section. 2. Remove the outboard seat trim shield. 3. Disconnect the electrical c ...

    Latch - Front Seat Backrest
    Removal NOTE: The power seat backrest adjuster assembly must be installed as a new unit. Repair of the power seat backrest adjuster assembly components is not acceptable and should not be attemp ...

    Other materials:

    Wheel
    Removal and Installation 1. Disconnect the battery ground cable (14301) and wait at least one minute to allow the depletion of the restraint system backup power supply. 2. Turn the steering wheel to the straight-ahead position and the ignition switch to ...

    Dual Converter Y-Pipe - 3.8L
    Removal NOTE: The RH and LH catalytic converters are serviceable separately. 1. Raise and support the vehicle. For additional information, refer to Section. 2. CAUTION: When repairing the exhaust system or removing exhaust components, disconnect all heated o ...

    Removal
    1. Remove the differential assembly from the differential housing. For additional information, refer to Differential Case in this section. 2. CAUTION: Record the torque necessary to maintain rotation of the drive pinion gear through several revolutions prio ...