Ford Mustang (1999-2004) Service Manual: Module
Removal
1. Remove the hydraulic control unit (HCU). Refer to Hydraulic Control Unit .
2. Remove the pump motor electrical connector.
3. Remove the anti-lock-brake control module screws.
4. Remove the anti-lock-brake control module from the HCU.
Installation
1. NOTE: The brake system must be bled after the HCU is installed or replaced.
To install, reverse the removal procedure.
Hydraulic Control Unit
Removal 1. Disconnect the battery ground cable(14301). 2. Disconnect the anti-lock-brake control module electrical connector. 3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction cont ...Sensor - Front
Removal 1. Remove the wheel and tire assembly. 2. Remove the inner fender splash shield. 1. Remove the inner fender splash shield push pins. 2. Remove the inner fender splash shield screw. 3. R ...Other materials:
Body Closures
General Specifications
Torque Specifications
Body Closures
The body closures consist of the following components:
door checks
front door
front door latch strikers
front door hinges
front door opening weatherstrips
hood
hood (Cobra) ...
Connecting Rod - Twist
1. Measure the connecting rod twist on a suitable alignment fixture.
Follow the instructions of the
fixture manufacturer. Verify the measurement is within specification.
Refer to the appropriate section in Group for the procedure.
If out of specificat ...
Vehicle Identification Number (VIN) Locator
The vehicle identification number (VIN) is a seventeen-digit alphanumeric
code. The VIN is stamped
on a metal tab riveted to the instrument panel, top upper left of the dash. The
VIN number is also found
on the vehicle certification (VC) label.
...