Ford Mustang (1999-2004) Service Manual: Moulding - Roof Side
Removal and Installation
1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws.
4. Remove the roof side moulding screw.
5. Release the clips.
1. Lift up to release the two clips.
2. NOTE: Grasp the roof side moulding and lift up to release the money clip.
Remove the money clip.
6. Remove the upper quarter trim panel. For additional information, refer to Section.
7. Remove the nuts and the roof side moulding.
8. To install, reverse the removal procedure.
Exterior Trim and Ornamentation
Torque Specifications Exterior Trim and Ornamentation The exterior trim and ornamentation consists of the following components: body side scoop hood scoop (if equipped) front spoiler ...Moulding - Rocker Panel
Removal 1. Remove the front rocker panel moulding screw. 2. Remove the strip. 3. Remove the rear rocker panel moulding screw. 4. Remove the pin-type retainers and the rocker panel moulding. ...Other materials:
Supercharger Cooling System Draining, Filling and
Bleeding
Draining
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid having scalding hot ...
Installation
1. Install the upper intake manifold gasket.
2. Install the intake manifold and bolts in the sequence shown.
3. Install the PCV valve-to-intake manifold tube.
4. Connect the vacuum hoses and the electrical connector to the EGR vacuum
regulator soleno ...
Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts.
Install a new driveshaft bearing retainer circlip.
2. Remove the special tool.
3. CAUTION: Differential seal damage will occur if installing the
halfshaft without the
special tool installed. ...