Ford Mustang (1999-2004) Service Manual: Muffler - 3.8L
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to Section.
2. Support the rear axle with a suitable jack.
3. Remove the upper arm-to-differential bolt.
4. Remove the nut and bolt and disconnect the rear shock absorbers (18124) from the axle housing.
- Discard the nut.
5. Lower the rear axle.
6. Remove the dual converter assembly flange nuts.
7. Remove the exhaust pipe assembly (5232) from the rear exhaust hanger insulator (5260).
8. Remove the exhaust hanger insulators.
9. Remove the muffler (5230).
10. CAUTION: Do not use oil or grease-based lubricants on insulators as they deteriorate the rubber.
NOTE: A soap-and-water solution will ease installation of the exhaust hanger insulators.
To install, reverse the removal procedure.
Exhaust System (Diagnosis and Testing)
Symptom Chart Condition Possible Sources Action Noisy or leaking exhaust Broken or loose clamps, hangers or isolators. Punctures in the muffler ( ...Muffler - 4.6L (2V)
Removal and Installation 1. Use a jack to support and lower the rear axle. 2. Remove the upper arm-to-differential bolt. 3. Remove the nut and bolt, and disconnect the rear shock absorbers (18124) ...Other materials:
Steering System Symptom Definitions
Drift/Pull
Pull is a tugging sensation, felt by the hands on the steering wheel, that
must be overcome to keep the
vehicle going straight.
Drift describes what a vehicle with this condition does with hands off the
steering wheel.
A vehicle-related drift/p ...
Pedal and Bracket
Removal
1. Disconnect the battery ground cable (14301).
2. Remove the stoplight switch retaining pin.
3. Slide the stoplight switch (13480) and booster push rod from the brake
pedal pin.
4. Remove the brake pedal bracket retaining bolt.
5. Remove the ...
Exhaust System (Diagnosis and Testing)
Symptom Chart
Condition
Possible Sources
Action
Noisy or
leaking
exhaust
Broken or loose
clamps, hangers or
isolators.
Punctures in the muffler
(5230).
Broken, loose or
missing exhaust
manifold fa ...