Ford Mustang (1999-2004) Service Manual: Removal
1. Disconnect the battery negative cable.
2. Drain the engine cooling system.
3. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold-LH in this section.
4. Remove the lower intake manifold. For additional information, refer to Lower Intake Manifold in this section.
5. Remove the push rods. For additional information, refer to Push Rod in this section.
6. Remove the drive belt.
7. Using the special tool, remove the power steering pump pulley.
8. Remove the power steering pump bracket.
9. Remove the generator bracket.
10. Remove the three exhaust manifold studs.
11. NOTE: Discard the cylinder head gasket.
NOTE: Record the location of the long bolts and the short bolts.
Remove the cylinder head. Discard the cylinder head bolts.
Cylinder Head LH
Special Tool(s) Remover, Power Steering Pump Pulley 211-016 (T69L-10300-B) Installer, Power Steering Pump Pulley 211-009 Material ...Installation
NOTE: Do not use a fiber disc to clean the surfaces. Fibers from the disc can get into the oil pan and oil and clog the oil bypass valve. 1. Clean and inspect the cylinder head for flatness. 2. ...Other materials:
Driveshaft (Description and Operation)
NOTE: All driveshaft assemblies are balanced. If undercoating the
vehicle, protect the driveshaft to
prevent overspray of any undercoating material.
The driveshaft has the following features:
A tubular shaft used to transfer engine torque from the ...
Piston - Ring-to-Groove Clearance
1. Inspect the piston for ring land damage or accelerated wear.
2. Measure the piston ring-to-groove clearance.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
to the a ...
Connecting Rod - Bushing Diameter
1. Measure the inner diameter of the connecting rod bushing, if equipped.
Verify the diameter is
within specification.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
...