Ford Mustang (1999-2004) Service Manual: Seal
Special Tool(s)
Installer, Transmission Extension Housing Oil Seal 308-227 (T94P-7657-A) | |
Slide Hammer 100-001 (T50T-100-A) | |
Remover, Bushing 307-001 (TOOL-1175-AC) or Equivalent |
Removal
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. CAUTION: Index-mark the driveshaft flange and pinion flange, and the driveshaft slip yoke and transmission output shaft.
Remove the driveshaft. For additional information, refer to Section.
3. Using the special tools, remove the extension housing fluid seal.
Installation
1. Using the special tool, install the extension housing fluid seal.
2. CAUTION: Align the index marks.
Install the driveshaft. For additional information, refer to Section.
3. Check the transmission fluid level, add fluid if necessary.
4. Lower the vehicle.
Bearings - Inspection
NOTE: If any of the following conditions exist, install a new bearing. 1. Inspect the bearing for a bent cage. 2. Inspect bearings for galling (metal smears on roller ends). Galling is caused ...Other materials:
Safety Precautions
WARNING: Never run the engine with one wheel off the ground, for
example, when
changing a tire. The wheel(s) resting on the ground could cause the vehicle to
move.
WARNING: The tire and wheel must always be correctly matched. It is very
important to
determ ...
Anti-Lock Control
Refer to Wiring Diagrams Cell 42 , Anti-Lock Brake for schematic and
connector information.
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent scan
tool
73 Digita ...
Engine Ignition (Description and Operation)
Eight separate ignition coils (12029):
are mounted directly above each spark plug (12405).
are controlled by the powertrain control module (PCM) for correct
firing sequence.
The spark plug:
changes the high voltage pulse into a spark which igni ...