Ford Mustang (1999-2004) Service Manual: Throttle Position (TP) Sensor

Removal

NOTE: The 3.8L engine is shown; the 4.6L (2V) is similar.

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the throttle position (TP) sensor.

  • Disconnect the connector.
  • Remove the screws, and remove the sensor.

Throttle Position (TP) Sensor

Installation

1. To install, reverse the removal procedure.

Throttle Position (TP) Sensor

Throttle Position (TP) Sensor -Cobra

Removal and Installation

1. Disconnect the throttle position (TP) sensor electrical connector.

Throttle Position (TP) Sensor -Cobra

2. Remove the bolts and the TP sensor.

Throttle Position (TP) Sensor -Cobra

3. To install, reverse the removal procedure.

Throttle Position (TP) Sensor -Mach I

Removal and Installation

1. Remove the air intake scoop bracket. For additional information, refer to Section.

2. Disconnect the throttle position (TP) sensor electrical connector.

Throttle Position (TP) Sensor -Mach I

3. Remove the bolts and the TP sensor.

Throttle Position (TP) Sensor -Mach I

4. To install, reverse the removal procedure.

    Powertrain Control Module (PCM)
    Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the RH front door scuff plate. 3. Remove the RH cowl side trim panel. Remove the ...

    Idle Air Control (IAC) Valve - 3.8L
    Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. NOTE: Discard the idle air control (IAC) valve gasket. Remove the IAC valve. Disconnec ...

    Other materials:

    Installation
    1. NOTE: If the lower intake manifold is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner. Allow to dry until there is no sign of wetness, or four minutes, whichever is longer. Failure t ...

    Door Speaker - Lower
    Removal and Installation 1. Remove the front door trim panel (239420). For additional information, refer to Section 2. Remove the speaker (18808). 1. Remove the screws. 2. Disconnect the electrical connector. 3. Remove the speaker. 3. ...

    Rear Subframe
    Removal and Installation CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if install ...