Ford Mustang (1999-2004) Service Manual: Camshaft
Special Tool(s)
|
|
Holding Tool, Camshaft 303-446 (T93P-6256-AHR) |
Material
| Item | Specification |
| Super Premium SAE 5W-20 Engine Oil XO-5W20-QSP or equivalent | WSS-M2C153- H |
Roller Followers
Special Tool(s)
Compressor, Valve Spring
303-452 (T93P-6565-AR)
Removal and Installation
1. Remove the LH and RH valve cover. For additional information, refer to
Valve Cover LH and
...
Removal
1. Remove the roller followers. For additional information, refer to Roller
Followers in this section.
2. Remove the LH timing chain for the LH side and both timing chains for the RH
side. For
addi ...
Other materials:
Fuel cut-off switch
WARNING: Failure to inspect and if necessary repair fuel leaks
after a collision may increase the risk of fire and serious injury.
Ford Motor Company recommends that the fuel system be inspected by
an authorized dealer after any collision.
In the event of a m ...
Torque Converter (Description and Operation)
The torque converter transmits and multiplies torque. The torque
converter is a four-element device:
impeller assembly
turbine assembly
reactor assembly
clutch and damper assembly
The standard torque converter components operate as follo ...
Disassembly
1. CAUTION: Do not place the cylinder head flat on the bench; the
valves will bend.
CAUTION: Before disassembly begins, mark the valve position on the face of each
valve being removed. The valves must be re-installed into the same positions.
Install the spec ...
