Ford Mustang (1999-2004) Service Manual: Clutch
General Specifications
Torque Specifications
- Clutch (Description and Operation)
- Disc and Pressure Plate - 3.8L and 4.6L (2V) Engines
- Disc and Pressure Plate - 4.6L (4V) Engine
- Pilot Bearing
- Flywheel Ring Gear
Dowels - Flywheel Housing to Block
Removal
1. NOTE: Take care not to damage the flywheel housing to block dowel
holes or the surface areas
around the flywheel housing to block dowel hole during removal.
Remove the two flywheel ho ...
Clutch (Description and Operation)
The primary function of the clutch is to couple and uncouple engine power
to the transmission upon
driver command.
The clutch is a single plate, dry friction clutch disc. The clutch
disc ha ...
Other materials:
Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear
General Specifications
Torque Specifications
Description
Nm
lb-ft
lb-in
Bolt retaining the differential pinion shaft to the
differential case
30
22
-
Bolt retaining the driveshaft yoke to the pinion flange
112
83
-
...
Trim Panel - Package Tray
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal and Installation
1. Remove the screw and the coat hook.
2. NOTE: Inspect the shoulder safety belt guide cover for damage. If the
shoulder safety belt guide
cover is d ...
Valve Cover LH
Material
Item
Specification
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
WSE-M4G323-A4
Removal and Installation
1. Position the oil level tube (6754) out of the way.
2. Disconnect the breather tube.
3. Separate the engine wir ...
