Ford Mustang (1999-2004) Service Manual: Control Assembly
Special Tool(s)
![]() |
Remover, Heater Control Cable Retainer 412-088 (T94P-18532-A) |
Control Components (Description and Operation)
Manual A/C
The climate control system heats or cools the vehicle interior depending on
the function selector
position and the temperature selected. Function selector position determines
heating or c ...
Removal
1. Remove the center instrument panel register.
2. Remove the screws.
3. Disconnect the connectors.
4. Using the special tool, disconnect the temperature control cable from the
control head.
5 ...
Other materials:
Ignition Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch d ...
Cable and Conduit
Removal
NOTE: The RH rear is shown, the LH is similar.
1. CAUTION: If any component in the parking brake system requires
repair or if the
rear axle housing (4010) is removed, the cable tension must be released.
Release the cable tension. For additional ...
Pinpoint Test C: LFC 29/DTC C1414 - Incorrect Vehicle Identification Code
Normal Operation
The restraints control module (RCM) monitors the electrical state of pins
10, 13 and 14 to determine if
it is installed on the correct vehicle. If the RCM detects an incorrect
condition on any of these pins, it
will store a diagnostic t ...

