Ford Mustang (1999-2004) Service Manual: Control Components
- Control Components (Description and Operation)
- Control Assembly
- Switch
- Resistor
- Vacuum Control Motor - Air Inlet Duct Door
- Vacuum Control Motor - Air Damper Door
Condenser to Evaporator Line
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a ...
Control Components (Description and Operation)
Manual A/C
The climate control system heats or cools the vehicle interior depending on
the function selector
position and the temperature selected. Function selector position determines
heating or c ...
Other materials:
Windshield wipers
Note: Fully defrost the windshield before switching on the windshield
wipers.
Note: Make sure you switch off the windshield wipers before entering a
car wash.
Note: Clean the windshield and wiper blades if they begin to leave
streaks or smears. If that does ...
Synchronizers
Disassembly and Assembly
NOTE: This procedure applies to all synchronizer assemblies.
1. Scribe an alignment mark on the sliding sleeve and the hub for assembly
reference.
2. Remove the sliding sleeve, then remove the synchronizer struts and the
springs.
3 ...
Camshaft Position (CMP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the camshaft position (CMP) sensor.
Disconnect the connector.
Remove the bolts and the sensor.
Installation
1. To install, reverse t ...
