Ford Mustang (1999-2004) Service Manual: Convertible Top Assembly - Rear Window Glass

Installation

1. Position the side rail and install the bolts. 2. NOTE: Tighten the bottom bolt first. Connect the mounting bracket and install the bolts. 3. NOTE: Line up the marks in the number four bow. Ti ...

Removal

1. Remove the rear defrost connectors if necessary. 2. Remove the nuts retaining the well sling and convertible top tacking strips. 3. Remove the three tacking strips. 4. Mark the top of the ...

Other materials:

Transmission Fluid Cooler Tubes
Removal 1. Disconnect the battery cables. 2. Raise and support the vehicle. For additional information, refer to Section. 3. Remove the nuts. 4. Remove the fluid cooler tube bracket at the engine. 5. NOTE: Use a backup wrench to hold the case fitting sec ...

Synchronizers
Disassembly and Assembly NOTE: This procedure applies to all synchronizer assemblies. 1. Scribe an alignment mark on the sliding sleeve and the hub for assembly reference. 2. Remove the sliding sleeve, then remove the synchronizer struts and the springs. 3 ...

Component Tests
Pressure Test 1. Turn the engine OFF. 2. WARNING: Never remove the pressure relief cap under any conditions while the engine is operating. Failure to follow these instructions could result in damage to the cooling system or engine and/or personal injury. To ...