Ford Mustang (1999-2004) Service Manual: Convertible Top
General Specifications

Torque Specifications

- Convertible Top (Description and Operation)
- Convertible Top (Diagnosis and Testing)
- System Bleeding
- Linkage Adjustment
- Convertible Top Assembly - Rear Window Glass
- Convertible Top Material
- Stay Pad - Convertible Top
- Hydraulic System, Lift Cylinder and Motor
Reservoir
Removal
1. Remove the LF wheel and tire. Refer to Section.
2. Position the front portion of the LF inner splash shield aside.
3. WARNING: Windshield washer solution contains methanol, which is ...
Convertible Top (Description and Operation)
Rear Window Glass Assembly
The convertible top assembly is equipped with a rear window glass
assembly. The rear window glass
assembly is permanently attached to the folding top rear ...
Other materials:
Push Rods - Inspection
1. CAUTION: Do not attempt to straighten push rods.
Check the ends of the push rods for nicks, grooves, roughness or
excessive wear. Install new
push rods as necessary. Refer to the appropriate section in Group 303 for
the procedure.
The push rods ca ...
Installation
1. Apply silicone gasket and sealant in the locations shown.
2. Install the engine front cover.
3. Install the belt idler pulleys and the bolts.
4. Connect the CMP sensor electrical connector.
5. Raise the vehicle.
6. Install the crankshaft fr ...
Removal
1. Remove the rear exterior trim mouldings.
2. Remove the clips
3. Remove the 13 Torx screws and the seal compression panel.
4. Remove the staples.
5. Remove the staples from the number one bow.
6. Remove the rear rail weatherstrip retainers from ea ...
