Ford Mustang (1999-2004) Service Manual: Disc

Removal

1. Remove the front disc brake caliper anchor plate (2B292). For additional information, refer to Brake Caliper Anchor Plate in this section.

2. Match mark the hub (1104) and the brake disc (1125).

Disc

3. If necessary, remove and discard the keeper nuts.

Disc

4. NOTE: If the brake disc cannot be easily removed, apply Rust Penetrant and Inhibitor F2AZ- 19A501-A or equivalent meeting Ford specification ESR-M99C56-A to the mating surfaces.

Remove the brake disc from the hub.

Installation

1. Clean rust and foreign material from the mating surfaces of the hub and brake disc.

  • Use Metal Brake Parts Cleaner F3AZ-19579-SA or equivalent to clean the brake disc and hub.

2. Apply High Temperature Nickel Anti-Seize Lubricant F6AZ-9L494-AA or equivalent meeting Ford specification ESE-M12A4-A to the hub flange.

Disc

3. Align the match marks and install the brake disc.

Disc

4. Install the anchor plate (2B292). 5. Check the total indicated runout (TIR).

    Brake Caliper Anchor Plate
    Removal 1. Remove the pads. For additional information, refer to Pads in this section. 2. Remove the anchor plate (2B292). 1. Remove and discard the anchor plate bolts. 2. Remove the ...

    Shield
    Removal 1. Remove the brake disc (1125). For additional information, refer to Disc in this section. 2. Remove the brake disc shield (2K004). 1. Drill out three brake disc shield rivets. ...

    Other materials:

    Mass Air Flow (MAF) Sensor - Mach I
    Removal CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element (internal to housing) or possible failure to the mass air f ...

    Exhaust Manifold - Inspection
    Special Tool(s) Straight Edge 303-D039 (D83L-4201-A) or equivalent 1. Place a straight edge across the exhaust manifold flanges and check for warping with a feeler gauge. Bearing -Inspection 1. Inspect bearings for the following defects. P ...

    Transmission (INSTALLATION)
    Special Tool(s) Retainer, Torque Converter 307-346 (T97T-7902-A) Material Item Specification Multi-Purpose Grease D0AZ-19584-AA ESB-M1C93- B MERCON V Automatic Transmission Fluid XT-5-QM, XT-5-DM MERCON V 1. CA ...