Ford Mustang (1999-2004) Service Manual: Ignition Switch Lock Cylinder - Functional

Removal and Installation

1. Disconnect the battery ground cable.

2. Remove the ignition switch lock cylinder (11582).

1. Insert the ignition key and turn to the RUN position.

2. Using a 1/8-inch drift, press the ignition switch lock cylinder release pin through the access hole while pulling out the ignition switch lock cylinder.

Ignition Switch Lock Cylinder - Functional

3. To install, reverse the removal procedure.

  • Verify ignition switch lock cylinder operation.

Ignition Switch Lock Cylinder - Functional

    Ignition Switch Lock Cylinder - Non-Functional
    Removal and Installation 1. NOTE: Make sure the front wheels are in the straight-ahead position. Disconnect the battery ground cable (14301) and wait at least one minute to allow the depletion of t ...

    Other materials:

    Exhaust Manifold LH
    Special Tool(s) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Support Bar, Engine 303-290-A Removal and Installation 1. Install the special tool. 2. Install the special tools. 3. Raise and support the vehicle. For additional ...

    Pinpoint Tests
    PINPOINT TEST A: THE ENGINE DOES NOT CRANK AND THE RELAY DOES CLICK Test Step Result / Action to Take A1 CHECK THE VOLTAGE TO THE STARTER RELAY YesGO to A2 . No REPAIR circuit 1050 (LG/VT) for an open. TEST the system for normal operation. ...

    Audible warnings and indicators
    Key In Ignition Warning Chime Sounds when the key is left in the ignition in the off or accessory position and the driver’s door is opened. Keyless Warning Alert (If Equipped) Sounds when the keyless vehicle is in RUN and the driver’s door is opened. Hea ...