Ford Mustang (1999-2004) Service Manual: Installation

1. Install the upper arm and bushing to the mounting bracket.

1. Position the arm and bushing.

2. Install a new nut and bolt. Do not tighten at this time.

Upper Arm

2. Connect the upper arm and bushing to the axle.

1. Position the arm and bushing.

2. Install a new nut and bolt. Do not tighten at this time.

Upper Arm

3. Raise the suspension until the shock absorber is compressed to the previously established alignment mark (curb height).

Upper Arm

4. Tighten the arm and bushing-to-mounting bracket bolt.

Upper Arm

5. Tighten the arm and bushing-to-axle bolt.

Upper Arm

6. Lower the suspension and remove the jack stand.

7. Lower the vehicle.

    Removal
    CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...

    Other materials:

    Differential Housing Cover
    Removal 1. Raise and support the vehicle. 2. NOTE: Empty the lubricant into a clean container for reuse. Remove the differential housing cover (4033). 1. Remove the 10 bolts and drain the lubricant from the differential housing (4010). 2. Remove the d ...

    Oil Pan
    Special Tool(s) Compressor, Coil Spring 204-D001 (D78P-5310-A) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) 3-Bar Engine Support Kit 303-F072 Material Item Specification Metal Surface Cleaner F4 ...

    Charging System (Description and Operation)
    The charging system is a negative ground system consisting of the following: generator internal voltage regulator charging system warning indicator storage battery necessary wiring and cables The generator is belt-driven by the engine ...