Ford Mustang (1999-2004) Service Manual: Power Steering
General Specifications
Torque Specifications
a - Once torque is reached, continue turning to align slot in nut with cotter pin hole in tie-rod.
- Power Steering (Description and Operation)
- Reservoir - CIII Pump
- Pump - CII
- Pump - CIII
- Pulley - CII Pump
- Pulley - CIII Pump
- Hose
- Cooler - Fluid
- Gear (Removal and Installation)
- Gear (Disassembly and Assembly)
Fill
1. WARNING: Do not mix oil types, any mixture or any unapproved oil can
lead to seal
deterioration and leaks. A leak can ultimately cause loss of fluid, which can
result in a
loss of power steering ...
Power Steering (Description and Operation)
System View
Steering System Components - 3.8L Engine
Steering System Components - 4.6L Engine
Steering Gear Mounting
Steering Gear
Power Steering Pump - CII
...
Other materials:
Sensor Indicator - Rear
Special Tool(s)
Pinion Bearing Cone Remover
205-D002 (D79P-4621A)
Axle Bearing/Seal Plate
205-090 (T75L-1165-B)
Sensing Ring Replacer
206-041 (T89P-20202-A)
Removal
1. Remove the rear axle shaft bearing.
2. Using the special ...
Disassembly
1. NOTE: The index mark on the output shaft must be aligned with the
index mark on the output
shaft ring gear during the assembly procedure.
Remove the ring gear snap ring.
2. Separate the ring gear and output shaft.
3. Remove the three output shaft seal ...
Front Subframe - 4.6L (2V) Engine
Special Tool(s)
Support Bar, Engine
303-290-A
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Removal and Installation
All vehicles
1. Remove the steering gear. For additional information, refer to Section.
2. Remove the lower co ...
