Ford Mustang (1999-2004) Service Manual: Switch - Door Lock
Removal
1. CAUTION: Place a rag between the window regulator switch plate and the door trim panel to avoid damaging the door trim panel.
Position the window regulator switch plate (14524) aside.
1. Pull at service notch.
2. Lift to release the clip at the rear edge.

2. Remove the screws and the door lock switch (14017).

Installation
1. To install, reverse the removal procedure.
Keyless Entry
The electronic door lock system has two main components:
- generic electronic module (GEM)(14B204)
- keyless entry remote transmitter (15K601)
Actuator - Door Lock
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the door latch (21812). For additional information, refer to
Latch-Door .
3. Remove ...
Keyless Entry (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for
schematic and connector
information.
Refer to Wiring Diagrams Cell 111 , Remote Keyless Entry (RKE) for
schematic and connec ...
Other materials:
Wheel
Removal and Installation
1. Disconnect the battery ground cable (14301) and wait at least one minute
to allow the depletion
of the restraint system backup power supply.
2. Turn the steering wheel to the straight-ahead position and the ignition
switch to ...
Manual transmission
Using the Clutch
Manual transmission vehicles have a starter interlock that prevents
starting the engine unless the clutch pedal is fully pressed.
To start the vehicle:
1. Make sure the parking brake is fully set.
2. Press the clutch pedal to the
floor, then ...
Front Subframe - 4.6L (2V) Engine
Special Tool(s)
Support Bar, Engine
303-290-A
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Removal and Installation
All vehicles
1. Remove the steering gear. For additional information, refer to Section.
2. Remove the lower co ...
