Ford Mustang (1999-2004) Service Manual: Accelerator Pedal and Shaft
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm.
2. Remove the accelerator pedal and shaft.
- Remove the nuts.
- Remove the accelerator pedal and shaft.
3. To install, reverse the removal procedure.
Acceleration Control (Diagnosis and Testing)
Inspection and Verification
1. Verify the customer's concern by operating the acceleration control system
to duplicate the
condition.
2. Inspect to determine if any of the following mechanical conce ...
Accelerator Cable - 3.8L
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconne ...
Other materials:
Caliper (Removal and Installation)
Special Tool(s)
Rear Caliper Piston Adjuster
206-026 (T87P-2588-A)
Removal
1. Raise the vehicle on a hoist.
2. Remove the wheel and tire assembly.
3. Disengage the parking brake cable end from the parking brake lever
arm.
4. Remov ...
Reporting safety defects (U.S. only)
If you believe that your vehicle has
a defect which could cause a crash
or could cause injury or death, you
should immediately inform the
National Highway Traffic Safety
Administration (NHTSA) in addition to notifying Ford Motor Company.
If NHTSA receives si ...
Installation
1. Install the bearing, snap ring, hub and dust shield. For additional
information, refer to Wheel
Hub-Cobra in this section.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do ...
