Ford Mustang (1999-2004) Service Manual: Fuel System
- Fuel System - General Information
- Fuel System (Description and Operation)
- Pressure Relief
- Fuel Tank Draining
- Spring Lock Couplings
- Fuel Line Fittings - Push Connect
- Fittings - R-Clip
- Fittings - Vapor Tube
- Fuel Tank and Lines
- Fuel Tank And Lines (Description and Operation)
- Fuel Tank
- Support Straps
- Fuel Pump Module
- Fuel Tank Filler Pipe
- Fuel Filter
- Acceleration Control
- Acceleration Control (Description and Operation)
- Acceleration Control (Diagnosis and Testing)
- Accelerator Pedal and Shaft
- Accelerator Cable - 3.8L
- Accelerator Cable - 4.6L (2V)
- Accelerator Cable - Supercharged Engine
- Accelerator Cable Bracket - 3.8L
- Accelerator Cable Bracket - 4.6L (2V)
- Accelerator Cable Bracket - Supercharged Engine
- Speed Control
Dual Converter H-Pipe - 4.6L (2V and 4V)
Removal
NOTE: The RH and LH catalytic converters are serviced separately.
1. Raise and support the vehicle. For additional information, refer to
Section.
2. CAUTION: When repairing exhaust system or ...
Fuel System - General Information
General Specifications
...
Other materials:
Master Cylinder - Hydro-Boost
Removal
1. Disconnect the fluid level sensor connector.
2. Disconnect the brake tubes.
3. Remove the brake master cylinder nuts.
4. Remove the brake master cylinder (2140).
Installation
1. To install, reverse the removal procedure.
Bleed the brak ...
Engine Cooling (Description and Operation)
CAUTION: Vehicle cooling systems are filled with Motorcraft Premium
Gold Engine
Coolant VC-7-A (in Oregon VC-7-B) or equivalent meeting Ford specification
WSS-M97B51-A1
(yellow color). Always fill the cooling system with the same coolant that is
present in ...
Key Programming - Additional Key With One Programmed
Key
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent
diagnostic tool
NOTE: This procedure is used when a customer needs to have an additional key
programmed into the
veh ...
