Ford Mustang (1999-2004) Service Manual: Air Intake Scoop
Removal and Installation
1. Disconnect the air intake scoop outlet from the air cleaner.
2. Disconnect the air intake scoop water drain hoses.
3. Remove the air intake scoop from the air intake scoop bracket.
- Remove the two air intake scoop bolts.
- Lift the air intake scoop from the air intake bracket studs.
4. To install, reverse the removal procedure.
Air Cleaner Element - 4.6L (2V)
Removal and Installation
1. Remove the air cleaner outlet tube (9B659). For additional
information, refer to Air Cleaner
Outlet Pipe-4.6L (2V) in this section.
2. Remove the mass air flow (MAF) ...
Air Intake Scoop Bracket
Removal and Installation
1. Remove the air intake scoop. For additional information, refer to Air
Intake Scoop in this section.
2. Remove the air intake scoop bracket nut at the throttle body.
...
Other materials:
Installation
1. Install the bearing.
1. Position the knuckle on the press.
2. Using the appropriate step plate adapter, press the bearing into the
knuckle until the
bearing clears the snap ring groove and bottoms out in the bore.
2. Install the snap ring.
3. CA ...
Bleeding - Components
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224, New Generation STAR (NGS)
Tester
418-F052, or equivalent scan
tool
NGS Flash Cable
418-F120 (007-00531) or
Equivalent
...
Disassembly
NOTE: The steering gear is serviceable as either a long or short rack
assembly. This procedure covers
the removal and installation of the components not supplied with a short rack
assembly. On short rack
assembly only the front wheel spindle tie-rods and fro ...
