Ford Mustang (1999-2004) Service Manual: Air Cleaner Element - 4.6L (2V)
Removal and Installation
1. Remove the air cleaner outlet tube (9B659). For additional information, refer to Air Cleaner Outlet Pipe-4.6L (2V) in this section.
2. Remove the mass air flow (MAF) assembly.
1. Release the clip.
2. Remove the MAF sensor assembly and position aside.
3. Remove the air cleaner element.
4. To install, reverse the removal procedure.
Air Cleaner Element -4.6L (4V)
Removal and Installation
1. Open the air cleaner housing.
2. Remove the element.
3. To install, reverse the removal procedure.
Air Cleaner Element - 3.8L
Removal and Installation
1. Remove the air cleaner outlet tube. For additional information, refer
to Air Cleaner Outlet Pipe-
3.8L in this section
2. Disconnect the connector.
3. Remove the ma ...
Air Intake Scoop
Removal and Installation
1. Disconnect the air intake scoop outlet from the air cleaner.
2. Disconnect the air intake scoop water drain hoses.
3. Remove the air intake scoop from the air intake s ...
Other materials:
Component Tests
Ball Joint Inspection
1. Raise and support the vehicle.
2. Prior to performing any inspection of the ball joints, inspect the wheel
bearings.
3. Position a safety stand beneath the front suspension lower arm (3079) to be
tested.
4. While an assistant pul ...
Crankshaft Front Oil Seal
Special Tool(s)
Crankshaft Seal
Installer/Aligner
303-335 (T88T-6701-A)
Front Cover Seal Remover
303-107 (T74P-6700-A)
Crankshaft Seal Installer
303-635
Crankshaft Damper Replacer
303-102 (T74P-6316-B)
...
Trim Panel - Upper Quarter
Special Tool(s)
Safety Belt Bolt Bit
501-010 (T77L-2100-A)
Removal and Installation
1. Remove the rear seat cushion.
2. Using the special tool, remove the rear safety belt anchor bolt.
3. Remove the screw and the coat hook.
4. Open the ...
