Ford Mustang (1999-2004) Service Manual: Caliper (Removal and Installation)
Special Tool(s)
|
|
Rear Caliper Piston Adjuster 206-026 (T87P-2588-A) |
Removal
1. Raise the vehicle on a hoist.
2. Remove the wheel and tire assembly.
3. Disengage the parking brake cable end from the parking brake lever arm.
4. Remove the parking brake cable retaining clip.
5. Remove the parking brake cable and conduit.
6. Remove the rear disc brake caliper brake hose bolt.
7. Remove the rear brake pin retainers (2N386) and remove the caliper.
Installation
1. NOTE: Use new copper washers.
Follow the removal procedure in reverse order.
- Bleed the brake system.
Rear Disc Brake (Description and Operation)
WARNING: Brake fluid contains polyglycol ethers and polyglycols.
Avoid contact with
eyes. Wash hands thoroughly after handling. If brake fluid contacts
eyes, flush eyes with
running water fo ...
Pads
Special Tool(s)
Rear Caliper Piston Adjuster
206-026 (T87P-2588-A)
...
Other materials:
Clutch Controls (Description and Operation)
The clutch control system engages and disengages the clutch. The clutch
control system disengages
the clutch when the clutch pedal is depressed and engages the clutch when the
clutch pedal is
released. Clutch pedal motion is transmitted by the c ...
Communication Circuit Wiring Repair
Special Tool(s)
Heat Gun
107-R0300 or equivalent
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Strip the wires.
3. NOTE: Use rosin core mildly activated (RMA) solder, not acid core
solder.
Solder ...
Generator - 4.6L 4V
Removal and Installation
1. Disconnect the battery. For additional information, refer to
Section.
2. Relieve the accessory drive belt tension and remove the belt from the
generator pulley.
3. Raise and support the vehicle. For additional informat ...
