Ford Mustang (1999-2004) Service Manual: Degas Bottle

Removal and Installation

1. Drain the coolant. For additional information, refer to Supercharger Cooling System Draining, Filling and Bleeding in this section.

2. Disconnect the coolant hoses.

Degas Bottle

3. Remove the bolts and the degas bottle.

Degas Bottle

4. To install, reverse the removal procedure.

 

    Radiator
    Removal and Installation 1. Drain the coolant. For additional information, refer to Supercharger Cooling System Draining, Filling and Bleeding in this section. 2. NOTE: RH is shown LH is similar. D ...

    Fuel Charging and Controls - 3.8L
    General Specifications Torque Specifications ...

    Other materials:

    Washer Pump
    Removal 1. Remove the LF wheel and tire. Refer to Section. 2. Position the front portion of the LF inner splash shield aside. 3. WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicate ...

    Rear Drive Halfshafts (Description and Operation)
    The rear wheel drive halfshaft system consists of and operates as follows: Halfshafts (4K138) transmit engine torque from the rear axle housing to the rear wheels. Halfshafts rotate at approximately one-third the speed of a driveshaft and do not cont ...

    Removal
    1. Raise and support the vehicle. 2. Remove the rear wheel and tire assemblies. 3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion bearing preload adjustment. CAUTION: Do not allow the calipers to hang from the brake hoses ...