Ford Mustang (1999-2004) Service Manual: Fuel Charging and Controls - 3.8L
General Specifications
Torque Specifications
Degas Bottle
Removal and Installation
1. Drain the coolant. For additional information, refer to Supercharger
Cooling System Draining,
Filling and Bleeding in this section.
2. Disconnect the coolant hoses.
...
Other materials:
Output Shaft Speed (OSS) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Disconnect the electrical connector.
3. Remove the output shaft speed (OSS) sensor.
4. To install, reverse the removal procedure. ...
System Air Flow Description
MAX A/C
When MAX A/C is selected:
The air inlet door vacuum control motor is at full vacuum, closing
off outside air and admitting
only recirculated air.
The panel/defrost door vacuum control motor is at full vacuum and
the panel/floor door vacu ...
Bearings - Inspection
NOTE: If any of the following conditions exist, install a new
bearing.
1. Inspect the bearing for a bent cage.
2. Inspect bearings for galling (metal smears on roller ends).
Galling is caused by overheating, poor lubrication or an overload
situatio ...
