Ford Mustang (1999-2004) Service Manual: Disc

Removal

1. Remove the rear disc support bracket (2B511). For additional information, refer to Support Bracket in this section.

2. Remove the brake disc (2C026).

Disc

Installation

1. Follow the removal procedure in reverse order.

    Installation
    1. CAUTION: Install the brake pads in full axle sets. Do not install new brake pads on only one side of vehicle. Install the new slipper and brake pads. 2. Position the caliper on the anchor ...

    Brake Caliper Support Bracket
    Removal 1. Raise and support the vehicle. 2. Remove the tire and wheel assembly. 3. CAUTION: Do not allow the rear disc brake caliper (2552) to hang from the rear wheel brake hose (2A442) ...

    Other materials:

    Manual Transmission and Clutch (Description and Operation)
    The primary function of the clutch is to couple and uncouple engine power to the transmission upon driver command. For additional information, refer to Section. Clutch Disc and Clutch Pressure Plate - 3.8L   Clutch Disc and Clutch Pressure Pl ...

    Torque Converter Cleaning And Inspection
    Material Item Specification MERCON V Automatic Transmission Fluid XT-5-QM, XT-5-DM MERCON V 1. If a new torque converter is being installed, continue with Substep 2 of Step 2. 2. If a new torque converter is not being installed, the fol ...

    Throttle Position (TP) Sensor
    Removal NOTE: The 3.8L engine is shown; the 4.6L (2V) is similar. 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the throttle position (TP) sensor. Disconnect the connector. Remove the screws, ...