Ford Mustang (1999-2004) Service Manual: Door - Air Inlet Duct

Removal

1. Remove the evaporator core housing. For additional information, refer to Section.

2. Disconnect the vacuum line.

Door - Air Inlet Duct

3. Remove the screws and remove the duct.

Door - Air Inlet Duct

Installation

1. To install, reverse the removal procedure.

 

    Plenum Chamber
    Removal 1. Remove the instrument panel. For additional information, refer to Section. 2. Remove the audio unit. For additional information, refer to Section. 3. If equipped, remove the CD player. Fo ...

    Heating and Ventilation
    General Specifications Torque Specifications ...

    Other materials:

    Glass, Frames and Mechanisms (Description and Operation)
    Component Location   Windshield Glass The windshield exterior mouldings are installed with the windshield glass. The windshield exterior mouldings cannot be replaced without removal of the windshield. Window Regulator Control Switch Power windows ...

    Assembly
    1. NOTE: Universal joint kits are to be installed as complete assemblies only. Do not mix components from other U-joint kits. Install the spider. 1. Start a new bearing cup into the driveshaft yoke. Check the needle bearings for correct positioning. ...

    Anti-Theft - Passive Anti-Theft System (PATS) (Description and Operation)
    The passive anti-theft system (PATS) contains the following components: theft indicator encoded ignition key transceiver module instrument cluster powertrain control module (PCM) standard corporate protocol (SCP) communication network The PATS uses rad ...