Ford Mustang (1999-2004) Service Manual: Fill

1. WARNING: Do not mix oil types, any mixture or any unapproved oil can lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering assist.

Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

2. Remove the fuel pump fuse from the battery junction box.

3. Raise the front wheels off the floor.

4. CAUTION: Do not crank the engine for more than 15 seconds at a time. Allow the starter to cool for 1 minute before cranking again. Premature starter failure can occur.

CAUTION: Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump will occur.

Turn the steering wheel from stop-to-stop while cranking the engine.

5. Lower the vehicle.

6. CAUTION: Do not overfill the reservoir.

Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

7. Install the fuel pump fuse.

 

    Purging - CIII Power Steering Pump
    Special Tool(s) Vacuum Pump 416-D002 (D95L-7559-A) or Equivalent CAUTION: If the air is not purged from the power steering system correctly, premature power steering pump failure ca ...

    Power Steering
    General Specifications Torque Specifications a - Once torque is reached, continue turning to align slot in nut with cotter pin hole in tie-rod. ...

    Other materials:

    Forward Clutch Cylinder
    Special Tool(s) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent Compressor, Clutch Spring 307-096 (T81P-70235-A) Protector, Transmission Forward Clutch Outer Fluid Seal 307-423 M ...

    Disassembly
    1. Remove the differential assembly from the differential housing. For additional information, refer to Differential Case in this section. 2. Remove the bolts. 3. CAUTION: Do not damage the threads in the bolt holes. Insert a punch in the bolt holes and d ...

    Wiper Blade and Pivot Arm Adjustment
    1. Cycle and park the windshield wipers. 2. Verify that the distance between the center of the RH windshield wiper blade and the top edge of the cowl top vent panel is within specification. 3. Verify that the distance between the center of the LH win ...