Ford Mustang (1999-2004) Service Manual: Intake Manifold - Upper

Engine

WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the following feat ...

Removal

1. Remove the air intake scoop bracket. For additonal information, refer to Section. 2. Remove the air cleaner outlet tube. For additional information, refer to Section. 3. Disconnect the accelera ...

Other materials:

Installation
1. Install the upper arm and bushing to the mounting bracket. 1. Position the arm and bushing. 2. Install a new nut and bolt. Do not tighten at this time. 2. Connect the upper arm and bushing to the axle. 1. Position the arm and bushing. 2. Install a ...

Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube
Removal and Installation NOTE: 3.8L shown, 4.6L (2V) similar. 1. With the vehicle in NEUTRAL, position it on a hoist. 2. Disconnect the exhaust gas recirculation (EGR) valve tube from the exhaust manifold. 3. Remove the differential feedback exhaust ga ...

Installation
1. NOTE: This procedure applies to both the LH and RH halfshafts. Install a new driveshaft bearing retainer circlip. 2. Remove the special tool. 3. CAUTION: Differential seal damage will occur if installing the halfshaft without the special tool installed. ...