Ford Mustang (1999-2004) Service Manual: Interior Lighting
Interior Lighting
The interior lighting system consists of the following:
- map/dome lamp assembly
- rear-high mount/cargo lamp assembly
- dimmer switch
- door ajar switch (located on the door latches)
- rear view mirror interior lamp (convertible only)
- courtesy lamp
- vanity mirror lamp assembly
- transmission range indicator
Lamp Switch - Brake Pedal Position (BPP)
Removal
1. Disconnect the battery ground cable.
2. Remove the brake pedal position (BPP) switch.
1. Remove the clip.
2. Remove the retainer.
3. Disconnect the electrical connector.
4. ...
Interior Lighting (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 111 , Remote Control Alarm and Lock System
for schematic and
connector information.
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for schematic
and ...
Other materials:
Throttle Position (TP) Sensor
Removal
NOTE: The 3.8L engine is shown; the 4.6L (2V) is similar.
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the throttle position (TP) sensor.
Disconnect the connector.
Remove the screws, ...
Pinpoint Tests - OSC Equipped Vehicles
Special Tool(s)
Breakout Box, EEC-V Control
System
418-049 (T94L-50-EEC-V) or
equivalent
MLP-TR Cable
418-F107 (007-00111) or
equivalent
Worldwide Diagnostic System
(WDS)
418-F224
New Generation STAR (NGS)
T ...
Wheel Bearing Check
1. WARNING: The electrical power to the air suspension system must be
shut off prior
to hoisting, jacking or towing an air suspension vehicle. This can be
accomplished by
turning off the air suspension switch. Failure to do so can result in unexpected
infla ...
