Ford Mustang (1999-2004) Service Manual: Lighting
- Exterior Lighting
- Headlamps
- Stoplamps
- Turn Signal and Hazard Lamps
- Parking, Rear and License Lamps
- Fog Lamps
- Reversing Lamps
- Headlamp Adjustment
- Bulb - Headlamp
- Lamp Assembly - Headlamp
- Lamp Assembly - Fog Lamp (GT)
- Lamp Assembly - Rear
- Lamp Switch - Headlamp
- Lamp Switch - Brake Pedal Position (BPP)
- Interior Lighting
- Daytime Running Lamps
Subwoofer Speaker - Convertible
Removal and Installation
1. Remove the rear quarter trim panel. For additional information,
refer to Section .
2. Remove the subwoofer assembly.
1. Disconnect the electrical connectors.
...
Exterior Lighting
Torque Specifications
Exterior Lighting
The exterior lighting system consists of the following components:
headlamps (13008)
parking lamps
rear lamps (13404)
high mounted stoplamp
...
Other materials:
Wipers and Washers (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for
schematic and connector
information.
Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic
and connector information.
Special Tool(s)
Alternator, Regulato ...
Compressor to Condenser Discharge Line - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when
repairing the ...
Temperature and Manifold Absolute Pressure (T-MAP)
Sensor - Cobra
Removal and Installation
1. Disconnect the temperature manifold absolute pressure (T-MAP)
sensor electrical connector.
2. Remove the bolts and the T-MAP sensor.
3. To install, reverse the removal procedure. ...
