Ford Mustang (1999-2004) Service Manual: Latch - Luggage Compartment Lid
Removal
1. NOTE: The luggage compartment lid latch is equipped with mechanical interior release handle.
Disconnect the luggage compartment lid lock actuator (432A38) cable.
2. Remove the luggage compartment lid latch (43200).
1. Disconnect the electrical connector.
2. Remove the three bolts.
Installation
1. To install, reverse the removal procedure.
Latch - Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Release the actuating rods by opening the clips.
3. Using a screwdriver, release the lock cyli ...
Handle - Exterior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Release the exterior door handle actuating rod by opening the clip.
3. Remove the exterior d ...
Other materials:
Accelerator Cable Bracket - 4.6L (2V)
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket.
For additional
information, refer to Section.
2. Disconnect the accelerator cable from the throttle body by rotating the
throttle body full open
and align ...
Switch - Traction Control
Removal and Installation
1. NOTE: If the vehicle is equipped with an automatic
transmission, position the shift lever in the 1
position before detaching the floor console finish panel.
Lifting from both sides, detach the floor console finish panel.
...
Principles of Operation
The vehicle has two module communications networks. The standard
corporate protocol (SCP) which
is an unshielded twisted pair cable (data bus plus, Circuit 914 [TN/OG] and
data bus minus, Circuit 915
[PK/LB]), and the international standards organization ...
