Ford Mustang (1999-2004) Service Manual: Pulley - CII Pump
Special Tool(s)
 |
Pump Pulley Installer 211-009 (T65P-3A733-C) |
 |
Pump Pulley Remover 211-016 (T69L-10300-B) |
Removal
1. Remove the drive belt.
2. Using the special tool, remove the pulley.
Installation
1. Using the special tool, install the pulley.
2. Install the drive belt.
Pump - CIII
Special Tool(s)
Teflon Seal Replacer Set
211-D027 (D90P-3517-A) or
equivalent
Removal and Installation
1. Remove the pulley. For additional information, refer to Pulley-CIII Pump
in ...
Pulley - CIII Pump
Special Tool(s)
Pump Pulley Replacer
211-185 (T91P-3A733-A)
Pump Pulley Remover
211-016 (T69L-10300-B)
Removal
1. Remove the drive belt.
2. Raise and support the vehicle.
3 ...
Other materials:
Fastening the safety belts
The front outboard and rear safety restraints in your vehicle are
combination lap and shoulder belts.
The presenter arm (available on the coupe only) is intended to improve
access to the safety belt and to allow access to the rear seat.
Rotate the presenter ...
Inspection and Verification
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid having scalding hot coolant ...
Crankshaft Front Seal
Special Tool(s)
Installer, Front Cover Oil Seal
303-335 (T88T-6701-A)
Installer, Crankshaft Front Oil
Seal
303-474 (T94P-6701-AH)
Remover, Oil Seal
303-409 (T92C-6700-CH)
Material
Removal
1. Remove the crankshaft pulley. ...
