Ford Mustang (1999-2004) Service Manual: Pump - CIII

Special Tool(s)

Teflon Seal Replacer Set 211-D027 (D90P-3517-A) or equivalent

Removal and Installation

1. Remove the pulley. For additional information, refer to Pulley-CIII Pump in this section.

2. Remove the bolt and bracket.

Pump - CIII

3. Disconnect the power steering hoses. Remove and discard the seal ring.

Pump - CIII

4. Remove bolts and the power steering pump (3A674).

Pump - CIII

5. To install, reverse the removal procedure.

  • Using the special tool, install a new seal ring.

Pump - CIII

 

Pump - CIII

6. Fill and leak check the power steering system.

    Pump - CII
    Special Tool(s) Teflon Seal Replacer Set 211D027 (D90P-3517-A) or equivalent Removal and Installation 1. Disconnect the power steering hose. Remove and discard the seal ring. 2. Di ...

    Pulley - CII Pump
    Special Tool(s) Pump Pulley Installer 211-009 (T65P-3A733-C) Pump Pulley Remover 211-016 (T69L-10300-B) Removal 1. Remove the drive belt. 2. Using the special tool, remove ...

    Other materials:

    Air Conditioning (A/C) System Check - Retail Procedure
    NOTE: This Retail Procedure is not eligible for claiming on Ford paid repairs (warranty and ESP). NOTE: The engine should be run at idle for 10 minutes with the air conditioning on and set to MAX A/C before carrying out this retail procedure. NOTE: Re ...

    Disassembly
    1. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate serrations for scores or burrs. Minor scores or burrs may be removed with crocus cloth. Install a new clutch cylinder if it is badly scored or damaged. 2. Check the fluid passage i ...

    Torque Converter Diagnosis
    Prior to the installation of a new or remanufactured torque converter, all diagnostic procedures must be followed. This is to prevent the unnecessary installation of torque converters. Only after a complete diagnostic evaluation can the decision be m ...