Ford Mustang (1999-2004) Service Manual: Gearshift Rail and Fork
Disassembly and Assembly
1. Using a 5/32-inch drift and a hammer, remove and discard the split pin. Slide the shift fork from the shift rail.
2. Remove the gearshift fork inserts.
3. CAUTION: Support the shift rail to prevent damage to the parts.
Position the gearshift fork on the shift rail. Align the split pin hole and install a new split pin.
4. Install the gear shift fork inserts.
Gearshift Rail Bushing
Special Tool(s)
Universal Puller Set
303-DS005 (D80L-100-A) or
equivalent
Installer, Shift Rail Bushing
308-244 (T96P-7025-F)
Slide Hammer
100-001 (T50T-100- ...
Transmission (Assembly)
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
Holding Fixture, Transmission
307-003 (T57L-500-B)
Remover/Inst ...
Other materials:
Disassembly
1. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate
serrations for scores or
burrs. Minor scores or burrs may be removed with a crocus cloth. Install a new
clutch cylinder if
badly scored or damaged.
2. Check fluid passage in the cl ...
Status bars
The top status bar shows the
current mode, exterior temperature,
time and display icons if you have
enabled Bluetooth or other options.
The bottom status bar shows the
Home icon and may show the
current driver and passenger
selected temperatures, fan speed a ...
Inspection and Verification
NOTE: Upon installation of a new GEM, the module must be
reconfigured. For additional information,
refer to Section.
1. The warning lamps are a GEM controlled system; refer to Section.
2. Verify the customer concern by operating the system in questio ...
