Ford Mustang (1999-2004) Service Manual: Pump - CII

Special Tool(s)

 Teflon Seal Replacer Set 211D027 (D90P-3517-A) or equivalent

Removal and Installation

1. Disconnect the power steering hose. Remove and discard the seal ring.

Pump - CII

2. Disconnect the power steering hose.

Pump - CII

3. Remove the pulley.

4. Remove bolts and the power steering pump (3A674).

Pump - CII

5. To install, reverse the removal procedure.

  • Using the special tool, install a new seal ring.

Pump - CII

 

Pump - CII

6. Fill and leak check the power steering system.

    Reservoir - CIII Pump
    Removal 1. Remove the bolts. 2. Disconnect the power steering hoses. Remove the reservoir. Installation 1. To install, reverse the removal procedure. 2. Fill and leak check the power steering sys ...

    Pump - CIII
    Special Tool(s) Teflon Seal Replacer Set 211-D027 (D90P-3517-A) or equivalent Removal and Installation 1. Remove the pulley. For additional information, refer to Pulley-CIII Pump in ...

    Other materials:

    Installation
    1. NOTE: This procedure applies to both the LH and RH halfshafts. Install a new driveshaft bearing retainer circlip. 2. Remove the special tool. 3. CAUTION: Differential seal damage will occur if installing the halfshaft without the special tool installed. ...

    Fastening the safety belts
    The front outboard and rear safety restraints in your vehicle are combination lap and shoulder belts. The presenter arm (available on the coupe only) is intended to improve access to the safety belt and to allow access to the rear seat. Rotate the presenter ...

    Evaporative Emission System Leak Test
    Special Tool(s) Evaporative Emission System Tester 310-F007 (134-00056) or equivalent Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool CAUTION: The evaporat ...