Ford Mustang (1999-2004) Service Manual: Rear Drive Axle and Differential
- The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket.
- The hypoid-design gearset consists of 8.8-inch ring gear (4209) and a
drive pinion gear (4209).
Two opposed tapered roller bearings support the drive pinion in the axle housing (4010).
- A collapsible spacer (4662), located on the differential pinion shaft, maintains pinion bearing preload. The pinion nut (389546-S100) adjusts the preload.
- Differential bearing shims (4067), located between the differential bearing cups (4222) and the rear axle housing, adjust the differential bearing preload and the ring gear backlash.
- The differential case (4204) is a one-piece design with two openings to allow for assembly of the internal components and lubricant flow. Two opposed tapered roller bearings (differential bearings) (4221) support the differential case in the axle housing. Removable bearing caps (4010) retain the differential assembly in the axle housing.
- Inside the differential case, the differential pinion shaft (4211) supports two differential pinion gears (4215). The pinion gears engage the differential side gears (4236), to which the axle shafts (4234) are splined. The differential pinion shaft lock bolt (4241) retains the differential pinion shaft in the differential case.
- An embossed metal tag, bolted to the differential housing cover, contains rear axle identification.
Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear
General Specifications
Torque Specifications
Description
Nm
lb-ft
lb-in
Bolt retaining the differential pinion shaft to the
differential case
30
22
-
Bolt retaining t ...
Other materials:
Auxiliary Power Points
WARNING: Do not plug optional electrical accessories into the
cigarette lighter socket (if equipped). Improper use of the lighter
can cause damage not covered by your warranty, and can result in fire
or serious injury.
Note: If used when the engine is not runn ...
Exterior Lighting
Torque Specifications
Exterior Lighting
The exterior lighting system consists of the following components:
headlamps (13008)
parking lamps
rear lamps (13404)
high mounted stoplamp
license lamps
front turn lamps
reversing lamps
fog ...
Transmission (Removal)
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Remove the gearshift lever knob.
3. Remove the console panel gearshift plate. Lift the gearshift lever boot
over the gearshift lever.
4. Remove the bolts and the sh ...
