Ford Mustang (1999-2004) Service Manual: Rear Spoiler
Removal and Installation
1. Open the luggage compartment lid.
2. Disconnect the high mounted stoplamp electrical connector.
3. Remove the screws and the nuts.
4. CAUTION: Use care not damge the pin-type retainers and pin-type retainer seals during removal.
Release the spoiler from the two pin-type retainers in an upward motion.
5. To install, reverse the removal procedure.
- Inspect the pin-type retainer seals. Install new pin-type retainer seals if damaged.
Moulding - Rocker Panel
Removal
1. Remove the front rocker panel moulding screw.
2. Remove the strip.
3. Remove the rear rocker panel moulding screw.
4. Remove the pin-type retainers and the rocker panel moulding.
...
Rear View Mirrors
Torque Specifications
Rear View Mirrors
The rear view mirror system consists of the following components:
exterior rear view mirror
exterior rear view mirror control
exterior rear view ...
Other materials:
Transmission Cooling - Integral
This vehicle with an automatic transmission is equipped with an integral
transmission fluid cooler. The
cooler is contained inside of the radiator outlet tank and cannot be serviced
separately. The cooler
transfers heat from the transmission fluid to the eng ...
Fuel Injectors
Material
Item
Specification
SAE 5W-20 Premium Synthetic
Blend Motor Oil
XO-5W20-QSP or equivalent
WSS-M2C153-
H
Removal and Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near ...
Idle Air Control (IAC) Valve - Mach I
Removal and Installation
1. Remove the air intake scoop. For additional
information, refer to Section.
2. Disconnect the idle air control (IAC) valve electrical connector.
3. Remove the bolts, the IAC valve and the gasket.
4. NOTE: Install a new ga ...
