Ford Mustang (1999-2004) Service Manual: Reservoir - CIII Pump
Removal
1. Remove the bolts.
2. Disconnect the power steering hoses. Remove the reservoir.
Installation
1. To install, reverse the removal procedure.
2. Fill and leak check the power steering system.
Power Steering (Description and Operation)
System View
Steering System Components - 3.8L Engine
Steering System Components - 4.6L Engine
Steering Gear Mounting
Steering Gear
Power Steering Pump - CII
...
Pump - CII
Special Tool(s)
Teflon Seal Replacer Set
211D027 (D90P-3517-A) or
equivalent
Removal and Installation
1. Disconnect the power steering hose. Remove and discard the seal ring.
2. Di ...
Other materials:
Accessory Drive Belt Idler Pulley - 4.6L (2V) and (4V)
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
Cobra
2. Remove the supercharger drive belt cover.
3. Rotate the supercharger belt tensioner clockwise and remove the
supercharger belt.
4. Remov ...
Front Bumper Cover
Removal and Installation
NOTE: Mustang shown, GT and Cobra similar.
1. Remove the pin-type retainers and the radiator upper sight shield.
2. Remove the two pin-type retainers (one each side).
3. Remove the four front bumper cover nuts (two each side).
4. ...
Installation
All vehicles
1. NOTE: Inspect the insulators for wear or damage. Install new
insulators if necessary.
Install the upper insulator on the spring.
2. Install the lower insulator on the lower arm.
3. Install the rear spring. Make sure the pigtail on the low ...
